Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
TORN DINETTE SLIDE SWEEP SEAL ISSUES!!!
#3
You might try checking the "squareness" of the slideout box with a carpenters square.
It will require blocking up a couple of surfaces and probably some additional innovation to make it so that the carpenters square will "fit" the slideout box.

I would also try to improvise a way to measure the slide out sides corner-to-corner.
The shop guys probably don't have the wherewithal to figure out how to measure it for squareness (if they even thought of that as a potential problem).
Reply


Messages In This Thread
Re: NEW DINETTE SLIDE ISSUES!!! - by eaglecapownerone - 09-24-2013, 01:46 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)