Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I spoke with the factory yesterday (12/11/13) at aprox 08:20 and had Brad (Warranty) and Bernie (lead tech) on speaker phone.
They have not done anything to the camper yet and were thinking of moving it into the service bay by the end of the day.

It sounds like they will remove the dinette slide box and start taking measurements of the cut out in the wall and the slide box.
I told them about the flexing of the floor and aso said that they should read the posts on this website and told them about having access to Ken Dawson ( engineer) if they wanted to get someone with engineering eyes to look at it. I do not know if they will.

They said several times that they understand my frustration and want to repair it once and for-all, as that is why they brought it back to the factory.

We will see and keep you posted....
While it is there I am having them also address
1) cabinet seem tape in several areas the tape edge is curling up away from the cabinet ( not sticking)
2) re-caulk the shower surround edge to the wall. (caulking cracked and is no longer sealing as water can now get behind the shower)
3) Wall cracking seems to be growing (see other post about wall cracking)
4) Interior trim around entry door pulling away again.
5) Interior trim wall to ceiling rear slide above loveseat pulling away and cracked.

I made a request for Brad to give me a bid to install a theater seating loveseat while they had the big slide out. It would be a great time to trade out the jack-knife love seat (useless as to short for a teen or adult to sleep on) for the new theater seating.  Lets hope they can do it!!

Stay tuned!!!!!

Attached Files Thumbnail(s)

Messages In This Thread
Re: TORN DINETTE SLIDE SWEEP SEAL ISSUES!!! - by rjchristensen - 12-12-2013, 07:21 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)